Oper Way To Put Hinge On Door And Jamb

I took all the doors off the hinges and the hinges off the jambs and doors in order to paint all the woodwork trim and doors in my house.

Oper way to put hinge on door and jamb.

Because we haven t routed for the hinges yet and they are still attached to the jamb it should be a snug fit for the width. If the existing jamb is out of square it will show up along the top. Attach hinges cut the head jamb to a length equal to the door width plus the combined rabbet or dado depth plus slightly more than 1 8 inch. From a mechanical point of view it doesn t make any difference and when installing factory assembled doors i keep the hinges however they are installed.

Notes on door hinge placement hinge placement varies depending on whether your door is left swing or right swing in swing or out swing. Once the door is shimmed all the way up tight to the quarter check the reveal along the top and the sides. I wasn t paying attention and forgot to note which part of the hinge goes back on the door and jamb. Lay the old door back on top of the new one and then transfer your hinge mortise lock set mortises and door hole outlines.

Trace around the hinge. Hinges have two parts one with 2 rings and another with 3 rings that the pin passes through. Use a combination square to lay out the mortises making sure that you re transferring the proper width and height of the outlines. Cut shims to match the dimensions of the hinge cutouts.

Door hinges which way is up. Double check to make sure that your outlines match the same location on the door and jamb before moving to the next step. When you install a door hinge you need to make notches for it on the edge of the door and on the jamb or the door won t close properly. Screw the door frame together with 2 1 2 inch screws.

The depth of the hinge on the jam should always be as thick as the hinge is. Using a mortising template route matching mortises for the hinges on the door and jamb. Attach it using your hammer and a nail or two. Put your hinge in place on the door and the jamb and use a carpenters pencil to carefully trace around the hinge.

However when hanging my own doors i like to put the three knuckle leaf on the door for the simple reason that it s easier to re hang the door. Step 2 insert a shim into the cutout. These notches or mortises should be just deep enough to.